Dana 50, 60 Front, 10 Bolt, 1999 and Newer, Differential Cover

PML Part Number 11169

PML makes two covers for this differential. Read About PML Dana 50/60 Front Covers.

Volume: 0.6 quarts over stock, approximately

Dimensions:Click here for dimensions. Approximately, this cover is 3.2 inches deep, which is 0.5 inches more than stock.

PML designed this PML Dana 50/60 front differential cover to clear the steering linkage and suspension on the front end of heavy duty trucks.

Benefits

• Extra capacity
• Fins
• Drain hole and magnetic drain plug
• Thick wall and flange sand cast aluminum construction

Applications

Generally, the 4 wheel drive models of these vehicles have a Dana 60 front differential and can use this cover.

• 1999 to 2016 Ford F–250 Super Duty Trucks, maybe 2017 and newer
• 1999 to 2016 Ford F–350 Super Duty Trucks, maybe 2017 and newer
• 1999 to 2016 Ford F–450 Super Duty Trucks, maybe 2017 and newer
• Some Ford Excursions
• Some 1994 to 2002 Ram 2500 and 3500 Trucks

Configurations vary! Always check your vehicle before ordering.

For Dodge Ram 2500 and 3500 vehicles, please check the cover dimensions and look at your trackbar bracket before ordering. Also, if your stock cover has a vent fitting (instead of having a vent on the differential housing), this differential cover cannot be used.

For 1997 and older Ford F250/350 trucks, this part will not clear the ring gear. Our pre–1999 Dana 50, 60 front cover will clear the ring gear.

Included With Cover

 Click on image to view larger.

This differential cover has a drain and a fill/level check hole.

A magnetic drain plug, fill/level check hole plug, and new mounting bolts are included.

Inside of Cover

 Click on image to view larger.

Compared to Stock

These images compare PML Dana 50/60 front differential covers and stock covers. Click on image to view larger in a new tab or window.

 

Older Versions of PML Front Dana 50/60 Differential Cover

PML has discontinued part numbers 9866 and 10737, older versions of a cover for the Dana 50/60 front differential.

For a larger picture, please click one of the above images. A separate window will open showing a bigger picture. (The larger pictures take a minute to display.)

PML Differential Cover Features:

• Increased oil capacity for cooler temperatures
• Sand-cast aluminum with raised fins
• 3/16-inch thick wall construction to add strength to differential housing
• 3/8-inch thick gasket flange will not bend when bolts are tightened
• Machined gasket surface for a secure seal using RTV or factory reusable gasket
• Oil changes without removing the cover
• All hardware provided, including magnetic drain plug

Learn more about finishes and construction of PML parts.